How to use an improved low nitrogen oxide burner?
Energy conservation and emission reduction is a basic national policy in China. The supply of oil resources is insufficient, and fuel prices continue to rise. Therefore, it is necessary to use low-cost alcohol based fuels as alternative energy sources. This has been rapidly applied abroad. The company specializes in developing a series of alcohol burners that utilize liquid fuels such as alcohol fuel, methanol, ethanol, and biofuels for combustion. In order to ensure good fuel combustion, it is necessary to improve the quality of fuel atomization and mix the oil mist with air. By using a burner. The burner is the key equipment of the oil-fired boiler, consisting of the fuel injection part (atomizer), air conditioning part, incineration stabilization device, electrical system, motor, servo motor, etc
Burner command: After power is applied, the burner starts and sparks are generated between the combustion electrodes. After about 13 seconds of pre blowing, the oil pump solenoid valve automatically opens, and the nozzle is pierced by sparks, igniting a flame. At this point, the flame detector senses the brightness of the flame and the controller locks it. The combustion electrode stops burning, with a delay of about 15 seconds, and the burner enters normal working state. If the incineration is unsuccessful, no flame is formed, or the flame detector cannot sense the brightness of the flame, for safety reasons, approximately 10 seconds later, the safety alarm system is activated, and the process begins to block the burner, resulting in a red malfunction light.
The manufacturer of the ultra-low nitrogen burner pointed out that when the burner is just started, if the flame detector senses brightness, the safety system will operate, the controller will not enter the normal program, the solenoid valve will not open, and the nozzle will not spray oil. About 10 minutes later, during safe time, the red light will go wrong. Therefore, when starting the burner, it is necessary to cover the flame detector when there is light, and do not let it see the light until the burner has flames. Release the flame detector immediately, otherwise the burner will not work properly. The recorder turns red and restarts after 3 minutes.
The incineration stabilization device consists of transformers, incineration electrodes, etc. The combustion stabilization device consists of an air conditioning board and a combustion head. The electrical system consists of a flame sensor, a combustion program controller, and a fuel heating controller. The motor servo motor provides power for Phoenix, oil pump, air valve regulation, and return oil regulation.
Low nitrogen burner manufacturer introduces product features: 1. Fuel is easy to buy, cheap, and the cost is 20-30% lower than using diesel or liquefied gas. 2. High thermal efficiency and strong firepower. 3. Emission reduction: Carbon dioxide and water after combustion. 4. Environmental protection: No smoke, no irritating odor, no oil droplets, no residue, no black pot bottom, no carbon accumulation, and the equipment and environment are clean. 5. Safety: extinguishing water in case of fire. 6. Convenience: Fuel is stored, transported, and used at room temperature and pressure. It can store ordinary iron or plastic barrels. 7. The gas turbine is equipped with an automatic program controller and an electric eye protection probe, using imported original electromagnetic pumps and nozzles. Stable quality and convenient maintenance.