Standard operation of fuel burner
The light diesel fuel used must be cleaned thoroughly, please pay attention to the timely cleaning of the fuel tank and oil filter; Under normal working conditions, replace the oil nozzle once a year, and replace the elastic coupling and rubber components on the coupling once a year; Prevent foreign objects from entering the air duct. The application area of the fuel burner should be far away from flammable and explosive materials, and rescue equipment should be equipped to adjust the oil pressure appropriately according to the indicated value of the oil pressure; Regularly inspect the combustion tube, impeller, flame detector, and ignition electrode to eliminate oil stains and carbon deposits. Especially, flame detectors should be kept clean and free from water; When protecting the fuel burner, the power supply must be blocked. Before using the oil burner, clean the residues in the combustion boiler, add new biomass Pellet fuel, and then close the charging tank cover. Before starting the operation, please check all circuits and water pipes to see if there are any abnormalities such as leaks or damage to the circuit. Check if the water pipe is leaking to avoid water leakage. Check if the cooling water in the water tank is full, and then open the fuel engine cooling valve to debug the air supply. It is suggested that the feeding system gradually increase the amount of biomass Pellet fuel. The entire process will last for three to five minutes. The entire process is to ensure that the fuel burner is energy-saving and environmentally friendly. Only by strictly following the operating instructions of the biomass burner can adjustments be made to ensure that the fuel burner can fully burn and play a significant role.
The fuel burner uses biomass Pellet fuel as the fuel, which can complete the regeneration and reuse of material resources and ensure that no pollutants are generated in the combustion process. Meanwhile, the energy-saving effect of the fuel burner is also very good, requiring only a small amount of biomass. Material Pellet fuel can generate huge heat energy. In application, it is necessary to ensure sufficient combustion to avoid resource waste. If the fuel burner burns continuously for a long time to generate heat energy, corresponding protective measures must be taken to avoid the waste of biomass Pellet fuel caused by defects and insufficient combustion during operation. Pay attention to environmental protection during use. A fuel burner is a device that can reduce combustion pollution, save energy, and protect the environment. However, if the operation manual is not followed during use, it will result in insufficient combustion, pollution, and resource waste. Therefore, when operating and using fuel burners, we must follow the operating instructions for standardized use, so that we can adjust and save resources, and achieve greater utilization of resources.